SeamStitch Silicone Caulk
Membrane Roofing / Fluid Applied Roofing / Elastomeric Roof Coating - 075600
Product Name
SeamStitch Silicone Caulk
Manufacturer
Lexis Coatings LLC
6460 Hwy 92 Ste 100
Acworth, GA 30102
United States
6460 Hwy 92 Ste 100
Acworth, GA 30102
United States
Product Description
SeamStitch Silicone Caulk is a solvent-based, single component, moisture cure, high solids, silicone caulk.
- May be used to seal around pipe boots, seams, curbs, flashing, penetrations and fasteners.
- Useful for spot repairs on our silicone roof coating system.
- Long term durability compared to acrylic caulks.
- Not affected by ponding water.
Technical Data
See table on the following page.
Installation
- Ready to use. Thinning is not necessary. Mix well before using.
- Roof must be clean, dry and free of any oil, grease, dirt or loosely adhered coating. Bare surfaces must be prepared and checked for compatibility.
- Follow our roof restoration procedures and always perform an adhesion test.
- Equipment: putty knife, bulk loader, sausage gun.
Availability and Cost
This product is available directly from Lexis Coatings and our authorized distributors.
Warranty
On pre-qualified and registered applications completed by Lexis-approved contractors, long term warranties are available. Contact Lexis Coatings for warranty information.
Maintenance
Read our Care and Maintenance Guidelines.
Technical Services
Contact Lexis Coatings for technical support.
Filing Services
Additional product information is available from Lexis Coatings.
Technical Data
| Property | Value | Method |
|---|---|---|
| Application Temperature | 50°F (and rising) - 95°F. Lower temperature and humidity will effect cure. | |
| Colors | White, Tan, Light Gray, Dark Gray | None |
| Cure Time | Tack Free: 1-2 hours, Cure Times: 12-18 hours | |
| Elongation | 275% | |
| Flash Point | 160°F | ASTM D-93 |
| Hardness | 50±5 (Shore A) | ASTM D-2240 |
| Packaging | 5 gallon pail | |
| Permeability | 4.2 perms | |
| SRI | 106 (Initial) | |
| Shelf Life | 12 months (Unopened Containers @ 50°F-85°F) | |
| Solids by Volume | 95% ±2% | ASTM D-2697-3 |
| Solids by Weight | 10.7 lbs/gal | |
| Tack Free | 1-2 Hours (Depending o humidity and temperature) | |
| Temperature Stability Range | -25°F - 175°F | |
| Tensile Strength | 130 | |
| VOC | <50 grams/liter | EPA Method 24 |